unable to create the error report
Comments
-
Hello @klmdss,
Thank you for reaching out to the Quicken Community, though I do apologize that you are experiencing this issue.
To start with, I suggest that you please try validating and/or super validating your data file. However, I do recommend that you first save a backup file prior to performing these steps.
Validate:- File
- Validate and Repair File...
- Validate File
- Click OK
- Close the Data Log
- Close Quicken (leave it closed for at least 5 secs)
- Reopen Quicken and see if the issue persists.
Super Validate:- File
- Hold CTRL + Shift and click Validate and Repair File...
- Super Validate File
- Click OK
- Close the Data Log
- Close Quicken (leave it closed for at least 5 secs)
- Reopen Quicken and see if the issue persists.
I hope this helps!
-Quicken Jasmine
Make sure to sign up for the email digest to see a round-up of your top posts.
0 -
Please verify this:
In Windows Control Panel / System / Advanced System Settings / Environment Variables ensure that both the TEMP and TMP variables point to a valid and existing folder, typically C:\Windows\Temp or
C:\Users\your_username_here\AppData\Local\Temp
If they point to an incorrect or non-existent folder or drive change both variables to an existing folder on C:\ (or create one) e.g., C:\Temp, and reboot Windows.If the Temp folder is located on a too-small SSD C: - drive and you have an internal standard hard disk, too, move the Temp folder to the internal hard disk and change the TEMP and TMP variables
If the folder exists … does your Windows User Account have proper access rights to this folder?
If Quicken cannot create and use temporary files, all sorts of malfunctions will occur.
If the Temp folder is full of junk, clean it out. Delete all files and subfolders within the Temp folder structure that Windows allows you to delete. You may have to skip a few that are actively in use.Make sure that files in the Temp folder are NOT accessed by cloud backup software at all.
Run CHKDSK C: /r on your C: - drive (or perform Error Checking from Windows File Explorer, Properties, Tools tab).
0 -
Getting same error message. Any advise.0
