Reports feature not working anymore

jerbark

When I run a transaction report, all of the info is squeezed together in the middle of the page (and no, it doesn't matter if I run with transaction detail or summary, etc). I can move the SINGLE column adjuster to see more detail, but if it's the third tier of detail i.e. "Donations/Charity/Boy Scouts", then it doesn't show the "boy scouts" detail at all. I've closed it and reopened it 2 times and it doesn't change.

UKR

If you haven't rebooted Windows since you installed the latest software update, please do so now and then try Quicken again.

Still not working?

Let's try some "Troubleshooting 101" to ensure the Quicken software is installed and updated properly and that your data file is in good working order.
Please perform all the steps in this document:
Troubleshooting 101 - Fixing Software Installation and Data File Problems

jerbark

Also, this happens now with previously saved reports as well an newly run reports

jerbark

I figure it out - the columns just got randomly redone, without any action on my part. I was able to reset them...however, another issue I have been having with Quicken 2019 is that my Memorized Reports just disappear. I usually have to reboot a couple of times before they come back??? Is anyone else having this problem?

UKR

If you haven't rebooted Windows since you installed the latest software update, please do so now and then try Quicken again.

Still not working?

Let's try some "Troubleshooting 101" to ensure the Quicken software is installed and updated properly and that your data file is in good working order.
Please perform all the steps in this document:
Troubleshooting 101 - Fixing Software Installation and Data File Problems