My monthly scheduled bills did not work for the last 2 months

MrZipp
MrZipp Member ✭✭✭
edited May 2022 in Registers & Transactions (Windows)
I noticed this and manually forced them to execute. I have had these working for years. Any ideas? January was fine, but February and March showed AUTO, but in the calendar payment list showed OVERDUE.

Thanks for any help
Tagged:

Best Answer

  • Quicken Anja
    Quicken Anja Moderator mod
    Answer ✓
    Hello @MrZipp,

    Thank you for reaching out to the Community and telling us about your issue, though I apologize that you are experiencing this.

    To start with, I suggest that you please try validating and/or super validating your data file. However, I do recommend that you first save a backup file prior to performing these steps.

    Validate: 
    1. File
    2. Validate and Repair File...
    3. Validate File
    4. Click OK
    5. Close the Data Log
    6. Close Quicken (leave it closed for at least 5 secs)
    7. Reopen Quicken and see if the issue persists.
    If the issue persists, proceed to Super Validate. If the issue is resolved after performing validation, then please disregard the instructions to Super Validate.

    Super Validate:
    1. File
    2. Hold CTRL + Shift and click Validate and Repair File...
    3. Super Validate File
    4. Click OK
    5. Close the Data Log
    6. Close Quicken (leave it closed for at least 5 secs)
    7. Reopen Quicken and see if the issue persists.

    I hope this helps!

    -Quicken Anja
    Make sure to sign up for the email digest to see a round up of your top posts.

Answers

  • Quicken Anja
    Quicken Anja Moderator mod
    Answer ✓
    Hello @MrZipp,

    Thank you for reaching out to the Community and telling us about your issue, though I apologize that you are experiencing this.

    To start with, I suggest that you please try validating and/or super validating your data file. However, I do recommend that you first save a backup file prior to performing these steps.

    Validate: 
    1. File
    2. Validate and Repair File...
    3. Validate File
    4. Click OK
    5. Close the Data Log
    6. Close Quicken (leave it closed for at least 5 secs)
    7. Reopen Quicken and see if the issue persists.
    If the issue persists, proceed to Super Validate. If the issue is resolved after performing validation, then please disregard the instructions to Super Validate.

    Super Validate:
    1. File
    2. Hold CTRL + Shift and click Validate and Repair File...
    3. Super Validate File
    4. Click OK
    5. Close the Data Log
    6. Close Quicken (leave it closed for at least 5 secs)
    7. Reopen Quicken and see if the issue persists.

    I hope this helps!

    -Quicken Anja
    Make sure to sign up for the email digest to see a round up of your top posts.

This discussion has been closed.

Categories