Should I install the R37.64 patch?

Question

I've seen the notification at:
https://community.quicken.com/discussion/7904926/resolved-12-31-21-new-entries-not-registering-with-version-release-r37-64

It mentions the .64 patch which can be installed to resolve the issue but I never installed the first, errant .64 update. I'm still on .62. When I check for updates in Quicken it says I have the latest version. I'm assuming this is because the fixed .64 has not been put into the mainstream yet.

Not sure I should install the interim .64 patch as it may be designed to just fix the errant .64 update rather than update me properly from .62 to .64. I'm not seeing anything in the discussion referenced above that states whether or not I should.

Thoughts?

Chris_QPW · Answer

Well, whether you want to install it or not really depends on if you think you need those fixes, which are really still in "staged release mode".  Otherwise, you can just wait until something is released to everyone.
BTW Note that announcement that you posted a link has been updated to include R37.65 with a link to install it.  For sure if I was going to install anything it would be R37.65 not R37.64 if you can even get it.

MSStateDawg · Answer

Hi, Chris. Thx for the feedback.

Did you have an opportunity to see the first paragraph in my post?

Chris_QPW · Answer

R37.64 has a known problem where manual entries aren't showing up until a restart or resorting of the register, that is why R37.65 is coming out right on its heels to fix that problem it introduced.

Note R37.64 has one fix in it that says that Quicken crashes sometimes on Online Billing.