FIND AND REPLACE

bill20
Member ✭✭
using version R32.12 build 27.1.32.12, my find and replace quit working, always shows no matching transactions found. I used a few different ones to be sure it was not working
0
Best Answer
-
Hello @bill20,
Thank you for reaching out to the Community to tell us about your issue, though I apologize that you are experiencing this.
To start with if you haven't already, I suggest you try to Validate your data file by following the steps below. However, I do recommend that you also save a backup of your data file first before trying these steps (just in case).- Navigate to the File menu
- Select File Operations
- Validate and Repair...
- Select Validate file
- Click OK
- Close the Data Log
- Close Quicken (leave it closed for at least 5 secs)
- Reopen Quicken and see if the issue persists.
Let us know how it goes!-Quicken Anja0
Answers
-
Hello @bill20,
Thank you for reaching out to the Community to tell us about your issue, though I apologize that you are experiencing this.
To start with if you haven't already, I suggest you try to Validate your data file by following the steps below. However, I do recommend that you also save a backup of your data file first before trying these steps (just in case).- Navigate to the File menu
- Select File Operations
- Validate and Repair...
- Select Validate file
- Click OK
- Close the Data Log
- Close Quicken (leave it closed for at least 5 secs)
- Reopen Quicken and see if the issue persists.
Let us know how it goes!-Quicken Anja0
This discussion has been closed.