Why does the calendar revert to 1/1/00?

Steve Schwartz
Steve Schwartz Member ✭✭
edited June 6 in Paying Bills, Online Billers & Reminders (Windows)
When I attempt to use a scheduled transaction in my calendar and change from SEND to ETF, it automatically changes the date to 1/1/00.

Best Answer

  • Quicken Anja
    Quicken Anja Moderator mod
    Answer ✓
    Hello @Steve Schwartz,

    Thank you for reaching out to the Community to tell us about your issue, though I apologize that you are experiencing this.

    Could you please provide which version of Quicken you have currently running?
    • Help > About Quicken

    The first thing that I suggest you try is to validate your data file by following the steps below.
    1. First save a backup of your data file (just in case) 
    2. Go to File
    3. File Operations
    4. Validate and Repair
    5. Validate File
    6. Ok
    7. Close the data log that will pop-up after the validation has completed
    8. Close Quicken
    9. Wait at least 5 seconds
    10. Reopen Quicken
    11. Try again to see if the issue reoccurs/remains the same or gets corrected
    You can also try super validating which are the same steps as above except that you will hold Ctrl and Shift on your keyboard when clicking on Validate and Repair in order to get the option for Super Validate.

    Let us know how it goes!
    -Quicken Anja

Answers

  • Quicken Anja
    Quicken Anja Moderator mod
    Answer ✓
    Hello @Steve Schwartz,

    Thank you for reaching out to the Community to tell us about your issue, though I apologize that you are experiencing this.

    Could you please provide which version of Quicken you have currently running?
    • Help > About Quicken

    The first thing that I suggest you try is to validate your data file by following the steps below.
    1. First save a backup of your data file (just in case) 
    2. Go to File
    3. File Operations
    4. Validate and Repair
    5. Validate File
    6. Ok
    7. Close the data log that will pop-up after the validation has completed
    8. Close Quicken
    9. Wait at least 5 seconds
    10. Reopen Quicken
    11. Try again to see if the issue reoccurs/remains the same or gets corrected
    You can also try super validating which are the same steps as above except that you will hold Ctrl and Shift on your keyboard when clicking on Validate and Repair in order to get the option for Super Validate.

    Let us know how it goes!
    -Quicken Anja
This discussion has been closed.

Categories